Ferrari 360 Cup Holder Conversion
Step 1
Remove the ash tray compartment. Slide up to remove.
Step 2
Remove the Philips head screw at the bottom. Store safely as it will be reused.
Step 3
Pull the ash tray up and unplug the cigarette lighter connector. Tuck the wires under the centre console out of the way.
Step 4
With the ash tray removed. Use a flat head screwdriver to gently pry the tabs on either side holding the lid in place. Be careful not to bend the tabs too much otherwise they may break.
While prying the side tabs, push on the underside of the lid to unclip the pin.
See video below
Step 5
Insert the lid into the cup holder conversion by using the inbuilt channels to guide the lid pins into position. Ensure correction orientation of the lid before doing this step.
See video below
Step 6
Once the lid is in place and is correctly seated, re install in your car with the original screw. Be very careful not to overtighten the screw as it may damage the item.
Step 7
Once the cup holder conversion is re installed, use the screw plug to cover the hole.
For removing this in the future, use needle nose pliers to help remove the plug.
Lid Removal
Adding Lid to Cup Holder
Disclaimer:
The installation instructions provided are intended as a general guide only. Performance Car Prints is not responsible for any damage or injury caused to you, your vehicle, or any property during installation or use of our products. Proceed at your own discretion and ensure all modifications comply with local laws and safety standards. If in doubt, seek professional assistance. Use of this guide is entirely at your own risk.